SPOTO CCIE LAB RS V5.0 H1 CFG Solution

Exam Pre-Configuration Instructions

1) The interface IP/IPv6 addresses have been configured

2) Some switches have been configured the VLAN information，there is one switch needs configure VLAN yourself, please check the pre-configurations.

3) The addresses information will note on the topologies, please check them with pre-configurations.

4) There is this command on R2 BGP VRF INET: network 123.2.2.2 mask 255.255.255.255, delete it.

If R2’s loopback0 was associated in VRF INET, move the interface to global and reconfigure IP address.

SECTION 1 Layer 2 Technologies

Section 1.1 VTP

Configure the ACME Headquarters network (AS 12345) as per the following requirements：

l the vtp domain must be set to CCIE

l use vtp version 2

l sw1 must be the vtp server and sw2 must be the vtp client

l secure all vtp updates with an MD5 digest of the ASCII string CCIErocks$

l in order to avoid as much as possible unknown unicast flooding in all vlans the administrator requires that any dynamic entries learned by other sw1 and sw2 must be retained for 2 hours before being refreshed.

Please pay attention to view the password on the exam

Solution：

SW1

vtp domain CCIE

vtp version 2

vtp mode server

vtp password CCIErocks$

SW2

vtp domain CCIE

vtp version 2

vtp mode client

vtp password CCIErocks$

SW1/SW2

mac address-table aging-time 7200

Configure the network of the new york office (AS 34567) as per the following requirements

l the vtp domain must be set to CCIE

l use vtp version 2

l sw3 and sw4 must not advertise their vlan config but must forward vtp
advertisement that they receive out their trunk ports

l secure all vtp updates with an MD5 digest of the ASCII strings CCIErocks$

Solution：

SW3/SW4

vtp domain CCIE

vtp version 2

vtp mode transparent

vtp password CCIErocks$

Section 1.2 Layer 2 Ports

configure your network as per the following requirements

l Complete the config of all vlans so that all routers that are located in ACME's
headquarters (AS12345) and new york office (AS 34567) can ping their directly connected neighbors

l all four switches (sw1-sw4) must have dot1q trunks that do not rely on negotiation

l do not configure any etherchannel

l ensure that the following unused ports on all four switches are shutdown and configured as access ports in vlan 999

E3/0-E3/3 are unused on sw1 and sw2
E1/0-E1/3 are unused on sw3 and sw4
E3/0-E3/3 are unused on sw3 and sw4

If you want to get more information, you can visit SPOTO CLUB.